In the table below, the explanation in the right-hand column shows what happens when you release the key after the specific number of flashes. The green status led will flash a number of times in sequence. With the printer power on and top cover closed, press and hold the feed button for several seconds. To exit the diagnostic mode and resume printing, turn the printer off and then on.
after printing the label, the printer will automatically enter a diagnostic mode in which the printer prints out a literal representation of all data subsequently received. The printer prints out a listing of its current configuration. With the printer power off, press and hold the feed button while you turn on the power. Refer to figure a for a sample configuration printout.įEED BUTTON MODES POWER-OFF MODE (COMMUNICATIONS DIAGNOSTICS MODE) The printer prints configuration information on the available media.
#Zpl printer driver
If you use varying label lengths, you can set the printer to measure the label length (using the Zebra driver or the ^Mf command) or return to auto- calibration by defaulting the printer.
#Zpl printer manual
NOTE: Performing a manual calibration disables the auto-calibration function. If this does not happen, try defaulting (hold the feed button until it flashes four times). upon completion, the printer will save the new settings in memory and the printer is ready for normal operation.
a profile of the media sensor settings (similar to the example below) will print.The printer will set the media sensor for the label backing being used and then automatically feed until a label is positioned at the printhead.Press and hold the feed button until the green status led flashes once, then twice.allow the printer to feed or error out.load the labels and ribbon (if used) and close the printer.Manual calibration is recommended whenever you are using pre-printed labels (or label backing) or if the printer will not correctly auto-calibrate.Note: If printing in Direct Thermal Mode, default the printer first (four flashes). Identify the indicator status using the table below, then refer to the relevant troubleshooting topic overleaf. The printer’s indicators display various printer functions and their statuses. This guide explains those indicators and procedures.
#Zpl printer series
To ensure that your Zebra printer continues to work efficiently and effectively, you need to understand the various indicators and testing procedures incorporated into the TlP and lP series printers. For instance, the font size is sent to the printer with the ^ADN,n,m command, where n and m are integers denoting the font size and spacing characteristics ^ADN,18,10 is the smallest size and ^ADN,180,100 the largest.ZEBRA® DESKTOP ZPL PRINTER TROUBLESHOOTING GUIDE Each format has to start with the command ^XA and end with ^XZ. The language commands always start with a caret (' ^') or tilde sign (' ~').
A possible use of ZBI could be for when the Zebra printer receives a foreign label format, which it would then convert to ZPL II on the fly so it can be printed.
#Zpl printer software
Primarily, it is intended to avoid a refactoring of code when changing the printer, if the old printer software was written by a label printer of a competitor. Later, the Zebra BASIC Interpreter ( ZBI) was integrated into printer software, which is seen as an advancement to ZPL II by the producer and is ANSI BASIC oriented. ZPL II is supported by some non-Zebra label printers. The original language was superseded by ZPL II, but it is not fully compatible with the older version. Zebra Programming Language ( ZPL) is a page description language from Zebra Technologies, used primarily for labeling applications.
0 kommentar(er)
